Pipelines

Business Type
Country
UAE
Category

Product Detail

TA Grade A Grade B Grade C Tensile strength, min, psi [MPa]Yield strength, min, psi [MPa] 48 000 [330] 30 000 [205] 60 000 [415] 70 000 [485] 35 000 [240] 40 000 [275] Elongation in 2 in. [50 mm], min, \'Yo: Basic minimum elongation transverse strip tests, and for all small sizes tested in full section When standard round 2-in. [50-mm] gage length test specimen is used For longitudinal strip tests For transverse strip tests, a deduction for each Vs2-in. [0.8-mm] decrease in wall thickness below 5/,6 in. [7.9 mm] from the basic minimum elongation of the following percentage shall be made Longitudinal 35 28 A Transverse Longitudinal 25 30 20 22 A 1.25 Transverse Longitu- Transverse dinal 16.5 30 16.5BLE 2 Tensile Requirements12 20 12 A 1.00 1.00 A The minimum elongation in 2 in. [50 mm] shall be determined by the following equation: e = 625 000A0 2 / U 0.9 for 81 units, and e = 1 940Ao.2 / U 0.9 for inch-pound units, where: e minimum elongation in 2 in. [50 mm], %, rounded to the nearest 0.5 %, A cross-sectional area of the tension test specimen, in.2 [mm2], based upon specified outside diameter or nominal specimen width and specified wall thickness, rounded to the nearest 0.01 in. 2 [1 mm2]. (If the area thus calculated is equal to or greater than 0.75 in. 2 [500 mm2], then the value 0.75 in.2 [500 mm2] shall be used.), and U specified tensile strength, psi [MPa].
Mr. Mohammed Imran
Contact Us Contact Details

Similar Products

Line Pipes

About our Company

Industry
Products
Line Pipes

Regional Suppliers

Line Pipes in UAE

Contact Us

Enlink Trading fze

Mr. Mohammed Imran

UAE

Send us a message